Did/Dnis - Panasonic DBS-2.3-400 Programming Manual

Chapter 1. System Programming (FF1)

DID/DNIS

Software Version: CPC-B Version 4.0 or higher
Address: FF1 8# 4# 6# (Trunk)# 2# (0-2)#
Description
Use this address to enable trunks for DID or DNIS calls.
• If DID is selected, the system will use the DID Numbers Table (see FF1
• If DNIS is selected (available only with T1 interface), the system will
The DID Numbers Table can be used for DID or DNIS. Therefore, if all 500
entries in the DNIS Numbers Table are filled, a T1 channel can be set to DID,
and DNIS service can still be used.
Programming
Related Programming
Inbound DID Dial Numbers: FF1 8# 3# (DIDNo.)# (ExtNo.)#
DNIS Number Setting: FF1 8# 4# 7# (DNISNo.)# (ExtNo.)#
DID/DNIS Flexible Ringing Assignments: FF1 8# (5# or 6#) (DID/DNIS
Notes
Digit Length Requirement. The DBS only supports 4-digit DID/DNIS
numbers.
CO Requirement. When the CO sends a DID/DNIS call to the DBS, it first
receives a "wink" signal from the DBS before sending the digits. Once the
wink is received, the CO should wait at least 200 ms before sending the
digits.
Power-Cycling Requirement. For changes to this parameter to take effect,
the system must be turned off, then back on.
Page 1-190
8# 3#) to determine which extension(s) will receive the DID call.
use the DNIS Numbers Table (see FF1 8# 4# 7#) to determine which
extension(s) will receive the DNIS call.
FF1 8# 4# 6# (1-64)# 2# (0-2)#
Trunk Number (1-64)
No.)# (ExtNo.)# (0000[00]-1111[11])#
DBS Manual - Revised April 2000
Section 400-Programming
0=Neither DID nor DNIS
is used.
1=DID is used.
2=DNIS is used.
DBS-2.3/9.2-400