Guard Timer; Table 1-39. T1 Guard Timer Values - Panasonic DBS-2.3-400 Programming Manual

Section 400-Programming

Guard Timer

Software Version: CPC-B Version 4.0 or higher
Address: FF1 8# 4# 2# 3# (0-15)#
Description
Determines how long the system guards a T1 circuit (1200 ms by default).
When the DBS "guards" a circuit, it holds the circuit after it has been released
to make sure the previous call is properly disconnected. This means the
channel cannot be used for another call until the Guard Timer has expired.
Programming

Table 1-39. T1 Guard Timer values

Notes
Power-Cycling Requirement. For changes to this parameter to take effect,
the system must be turned off, then back on.
DBS-2.3/9.2-400
FF1 8# 4# 2# 3# (0-15)#
Setting
0 200 ms
1 300 ms
2 400 ms
3 500 ms
4 800 ms
5 1000 ms
6 1200 ms
7 1400 ms
8 1600 ms
9 1800 ms
10 2000 ms
11 2200 ms
12 2400 ms
13 2600 ms
14 2800 ms
15 3000 ms
DBS Manual - Revised April 2000
Chapter 1. System Programming (FF1)
Guard Timer setting
Default: 6 (1200 ms) (see table below)
Value
Page 1-149