Least Cost Routing (Lcr) Access - Panasonic DBS-2.3-400 Programming Manual

Chapter 1. System Programming (FF1)

Least Cost Routing (LCR) Access

Software Version: All Versions
Address: FF1 2# 1# 3# (0 or 1)#
Description
This program specifies whether Least Cost Routing (LCR) is used when "9"
is dialed to make an outside call.
Programming
Related Programming
Forced Least Cost Routing: FF3 (ExtPort)# 4# (0 or 1)#
LCR Settings: all FF8 programs
Notes
Restriction With Call Forward-Outside Feature (in CPC-AII and CPC-B
Version 7.0 and above). LCR will not work with the Call Forward-Outside
feature. If LCR is activated (the above address is set to "1"), extensions set to
Call Forward-Outside must use trunk groups 1-6 (trunk group "9" cannot be
used). See Section 700-Feature Operation for more information.
Required Hardware Setting. Cut strap S1 on the CPC card to enable LCR.
See Section 300-Installation for instructions.
FCC Registration. If strap S1 is cut, a different FCC registration number
should be used to identify the DBS system. Both registration numbers -- one
for the DBS as a PBX system (S1 is cut), and one for the DBS as a KSU (S1
is not cut) -- are printed on a label in the main cabinet. See Section 300-
Installation for more information.
Page 1-8
FF1 2# 1# 3# (0 or 1)#
0="9" indicates a pooled-trunk call.
1="9" indicates an LCR call.
DBS Manual - Revised April 2000
Section 400-Programming
DBS-2.3/9.2-400