Table of Contents
Advertisement
Section 400-Programming
Automatic Day Mode Start Time
Software Version: CPC-AII (all versions) and CPC-B Version 4.0 or higher
Address: FF1 3# 29# HHMM#
Description
Setting the Automatic Day Mode Start Time allows the DBS to switch from
Night mode to Day mode automatically.
You can program trunks to ring incoming calls at different extensions during
Day or Night mode (see FF4 addresses). And different TRS types can be
programmed for use in each mode (see FF8 addresses).
To set the automatic start time for Night mode, use FF1 3# 1# HHMM. A
second Night mode is also available in Version 7.0 or higher of CPC-AII or
CPC-B -- see FF1 3# 30# HHMM.
Programming
To set the Automatic Day Mode Start Time ...
Enter the time using the 24-hour format. The following example sets the time
to 8:30 a.m.:
To clear the Start Time (disable Day Mode) ...
Related Programming
Time Setting: FF1 1# 2# HHMM#
Automatic Night Mode Start Time: FF1 3# 1# HHMM#
Automatic Night 2 Mode Start Time: FF1 3# 30# HHMM#
CO Ring Assignments: FF4 addresses
Toll Restriction: FF8 addresses
DBS-2.3/9.2-400
FF1 3# 29# 0830#
FF1 3# 29# CONF ON/OFF
DBS Manual - Revised April 2000
Chapter 1. System Programming (FF1)
Time Setting (8:30 a.m.)
(in 24-hour format)
Page 1-125
Advertisement
Table of Contents
