T1 Trunk Type Emulation - Panasonic DBS-2.3-400 Programming Manual

Section 400-Programming

T1 Trunk Type Emulation

Software Version: CPC-B Version 4.0 or higher
Address: FF1 8# 4# 6# (Trunk)# 1# (0-3)#
Description
Determines the type of trunk signaling that each T1 channel emulates (E&M
by default).
Programming
Notes
Power-Cycling Requirement. For changes to this parameter to take effect,
the system must be turned off, then back on.
Ground Start Requirement. If your system uses T1 COP (Central Office
Protocol) Version 1.1 or 1.2, it must be upgraded to Version 1.4 or higher if
you wish to use the "Ground Start" setting.
DBS-2.3/9.2-400
FF1 8# 4# 6# (1-64)# 1# (0-3)#
Trunk Number (1-64)
DBS Manual - Revised April 2000
Chapter 1. System Programming (FF1)
0=Loop Start
1=(reserved for future use)
2=Ground Start (used for
ground start emulation)
3=E&M
Page 1-189