Fourth Attendant Position - Panasonic DBS-2.3-400 Programming Manual

Chapter 1. System Programming (FF1)

Fourth Attendant Position

Software Version: CPC-AII (all versions) and CPC-B Version 2.0 or higher
Address: FF1 2# 1# 26# (11-69 or 101-699)#
Description
This address assigns an extension number as the Fourth Attendant position.
By default, no extension is assigned as the Fourth Attendant.
When all line appearances at the Primary Attendant are busy, calls will
transfer in sequence to the Second, Third, and Fourth Attendants. If all line
appearances are busy on all Attendants, calls will transfer to the Attendant
Transfer Extension (if assigned).
Programming
To assign a Fourth Attendant position ...
To clear the Fourth Attendant position ...
Related Programming
Extension Number Digits: FF1 2# 1# 12# (0 or 1)##
Second Attendant Position: FF1 2# 1# 24# (11-69 or 101-699)#
Third Attendant Position: FF1 2# 1# 25# (11-69 or 101-699)#
Attendant Transfer Extension: FF1 2# 1# 27# (11-69 or 101-699)#
Extension Numbers (assigning to ports): FF3 (ExtPort)# 1# (ExtNo.)#
Notes
Programming Restrictions. A telephone must be plugged into the Fourth
Attendant port before its extension number can be programmed or cleared.
Also, use another phone to program or clear its extension number (e.g., you
can't use ext. 103's phone to program ext. 103 as the Fourth Attendant
position).
Limitation on Assigning the Fourth Attendant. The DBS system will not
allow you to assign extension 10 or 100 as the Fourth Attendant position.
This is the system default for the Primary Attendant phone, which cannot be
changed.
Page 1-34
FF1 2# 1# 26# (11-69 or 101 to 699)#
(default: no Fourth Attendant assigned)
FF1 2# 1# 26# CONF ON/OFF
DBS Manual - Revised April 2000
Section 400-Programming
Extension Number
DBS-2.3/9.2-400