Table of Contents
Advertisement
Appendix B. Terminal Programming
Terminal Programming Through a CO or DISA Trunk
Note: To enter the Terminal Programming mode through a trunk, the DBS
must be equipped with an MFR card (if using DISA) and an RAI card.
To program through a CO or DISA trunk:
1. Dial into the DBS through the trunk.
2. Ask the operator to place you on hold and dial #6 xxxx (where "xxxx" is
3. Wait for the computer to display "REMT>", then type P and press
4. Follow the directions on the screen to access the desired program.
Terminal Programming Commands
Use the following commands to navigate terminal programming:
Table B-1. Terminal programming commands
Page B-2
the site's password; system default is "9999"). This will transfer you to the
RAI-A&B cards.
ENTER.
Command
~01
Access System parameters
~02
Access Trunk parameters
~03
Access Extension parameters
~04
Access Ring assignments
~05
Access FF key assignments
~06
Access Name assignments
~07
Access Toll Restriction data
~08
Access Least Cost Routing data
~09
Access Copy mode
~10
Access Speed Dial data
~B
Back to previous address
~b
Back to previous port
~F
Forward to next address
~f
Forward to next port
~R
Return to previous mode
Ctrl-Z
Quit
DBS Manual - Revised April 2000
Section 400-Programming
Description
DBS-2.3/9.2-400
Advertisement
Table of Contents
