Table of Contents
Advertisement
Chapter 1. System Programming (FF1)
SLT Flash Control
Software Version: All Versions
Address: FF1 2# 1# 11# (0 or 1)#
Description
This address determines how the DBS will respond to a second hookflash
during a call transfer on an SLT (Single-Line Telephone). By default, the
second hookflash will retrieve the held call.
To transfer a call on an SLT, the user hookflashes to place the call on hold,
then dials the extension number to transfer the call to. If the extension is busy
or not answered, the SLT user can hookflash again to either return to dial tone
or retrieve the held call, depending on the setting ("0" or "1", respectively) in
this address.
The following table further explains the SLT call transfer process for both
settings:
Table 1-2. SLT Hookflash Control Settings
If SLT Flash Control Is Set to "0" ...
-- The user hookflashes to place a call
on hold.
-- The user dials an extension number
to transfer the call. The extension is
busy or does not answer.
-- The user hookflashes a second time
to receive dial tone.
-- The user dials another extension*.
-- When the extension rings, the user
hangs up to transfer the held call.
* Or, the user can hookflash a third
time to retrieve the held call.
NOTE: This address does not affect how the hookflash functions when the
SLT user is listening to dial tone.
Page 1-16
DBS Manual - Revised April 2000
Section 400-Programming
If SLT Flash Control Is Set to "1" ...
-- The user hookflashes to place a call
on hold.
-- The user dials an extension number
to transfer the call. The extension is
busy.
-- The user hookflashes a second time
to retrieve the held call.
-- The user can then hookflash a third
time to place the call on hold and
receive dial tone.
-- The user dials another extension.
-- When the extension rings, the user
hangs up to transfer the held call.
DBS-2.3/9.2-400
Advertisement
Table of Contents
