Table of Contents
Advertisement
Chapter 1. System Programming (FF1)
LCD Timer for Caller ID
Software Version: CPC-AII and CPC-B, Version 6.1 or higher
Address:
FF1 2# 1# 38# (0, 1 or 2)#
Description
The LCD Timer determines how long the DBS waits before displaying call
duration timing on the phone's LCD. This Timer allows Caller ID
information (if available) to appear before the call duration timing is
displayed.
For example, if the LCD Timer is set to 5 seconds (default), call duration
timing will start displaying on the phone's LCD 5 seconds after an outgoing
number is dialed, or 5 seconds after an incoming call is answered.
Programming
Related Programming
Call Duration Display: FF1 2# 1# 1# (0 or 1)#
SMDR Display Start Timer for CO Calls: FF1 2# 1# 2# (0, 1 or 2)#
Notes
SMDR Interaction. The LCD Timer only affects the display of call duration.
The system begins the actual SMDR recording of the call according to the
SMDR Start Timer address (FF1 2# 1# 2#). In order for call duration to be
displayed, the LCD Timer has to expire after the SMDR Start Timer -- which
means the LCD Timer setting must be equal to or greater than the SMDR
Start Timer.
Caller ID Interaction. The LCD Timer setting will be the actual length of
time that Caller ID information is displayed before the LCD changes to call
duration timing. However, the Timer also controls when call duration display
begins for all types of trunk calls, not just Caller ID calls.
Page 1-50
FF1 2# 1# 38# (0, 1 or 2)#
DBS Manual - Revised April 2000
Section 400-Programming
0=5 seconds
1=16 seconds
2=30 seconds
DBS-2.3/9.2-400
Advertisement
Table of Contents
