Table of Contents
Advertisement
Section 400-Programming
EM/24 Port Assignment
Software Version: All Versions
Address: FF3 (ExtPort)# 3# (ExtPort)#
Description
This program assigns an EM/24 terminal to a key phone by associating the
extension ports.
EM/24 terminals provide additional FF keys to a key phone. An EM/24
terminal needs its own extension port. This address therefore requires two
port number entries -- one for the EM/24 terminal, and one for the key phone.
After the EM/24 is assigned to the key phone, the key phone's extension port
should be used in other program addresses (for example, when including the
phone in a hunt group or call coverage group).
Programming
To assign an EM/24 to a key phone ...
To clear an EM/24 assignment ...
Notes
Reconnection Requirement. After manually reprogramming the EM/24
terminal, disconnect its module jack, then reconnect it.
Changing Default Key Assignments in CPC-B Versions 2.01 to 2.04. When
you change default EM/24 key assignments in these versions, reprogram as
follows:
1. Assign the EM/24 to a port.
2. Reset the EM/24 by unplugging then reconnecting it.
3. Program the keys using FF5 (ExtPort)# (FFkey)#.
DBS-2.3/9.2-400
FF3 (1-144)# 3# (1-144)#
EM/24 Port
FF3 (1-144)# 3# CONF ON/OFF
EM/24 Port
DBS Manual - Revised April 2000
Chapter 3. Extension Programming (FF3)
Key Phone Port
Page 3-7
Advertisement
Table of Contents
