Attendant Led Alarm Indication - Panasonic DBS-2.3-400 Programming Manual

Section 400-Programming

Attendant LED Alarm Indication

Software Version: CPC-B Versions 2.09 to 4.0 (requires Attendant Feature Package)
Address: FF1 2# 1# 29# (0 or 1)#
Description
Use this address to allow or disallow the Alarm feature (LED lights to
indicate an alarm condition) to be assigned to an FF key on an Attendant
phone. By default, the Alarm feature can be assigned.
NOTE: The Attendant Feature Package (AFP) was discontinued in CPC-B
Version 5.0.
Programming
Related Programming
AFP Key Assignments: FF5 (149-152)# (1-72)# (FF12 4)#
Notes
Installing AFP. Installation of the AFP software requires the replacement of
EPROM Chip 1 on the CPC-B card with an AFP chip. Make sure the new
chip is installed in the proper direction. See Technote 4 (September 1991) for
complete information.
DBS-2.3/9.2-400
FF1 2# 1# 29# (0 or 1)#
0=Alarm feature cannot be assigned to Attendant FF key.
1=Alarm feature can be assigned to Attendant FF key.
DBS Manual - Revised April 2000
Chapter 1. System Programming (FF1)
Page 1-37