Table of Contents
Advertisement
Section 400-Programming
Country Code Table
Software Version: CPC-A Version 4.0 or higher; CPC-AII/B Version 6.0 or higher
Address: FF7 1# 20# (Table)# (Code)#
Description
This address applies only to systems programmed to use the new NANP
dialing plan (FF7 1# 17# 1#). Also, this switch applies only to TRS types 3-6
(TRS types 0-2 do not allow international dialing; TRS type 7 allows all
dialing).
In this address, the DBS provides a Country Code Table of up to 10 allowable
country code entries for placing international calls. Each entry can be 1 to 3
digits long.
Programming
Related Programming
International Calling For TRS Types 3-6: FF7 1# 1# (0 or 1)#
Dialing Plan Switch: FF7 1# 17# (0 or 1)#
International Calling on Extensions: FF7 1# 19# (ExtPort)# (0 or 1)#
Notes
Country Code Usage. Country codes are used as follows:
• When a phone user accesses a trunk assigned TRS type 3-6 and then dials
• If the switch is enabled, the DBS then checks the international calling
• If it is checked, the call will be allowed only if the dialed country code
Short Country Codes. When country codes of less than 3 digits are entered,
the system will allow any country code that begins with that number or
numbers. For example, an entry of "9" allows all two- and three-digit country
codes beginning with "9." Likewise, an entry of "26" allows all three-digit
country codes beginning with "26."
Digit Restriction. The system will not accept country codes that begin with
"1" (this is reserved for U.S. calls).
DBS-2.3/9.2-400
FF7 1# 20# (1-10)# (0-999)#
01 or 011, the system first checks the international calling restriction set
for the extension (in FF7 1# 19#).
restriction set for the system (in FF7 1# 1#), which determines if the
Country Code Table is checked before an international call is processed.
appears in the Table.
DBS Manual - Revised April 2000
Chapter 7. Toll Restriction (FF7)
Table Entry
Country Code Entry
Page 7-13
Advertisement
Table of Contents
