Relay Pcb 1 - Canon iR C3200 Series Service Manual

12.5.12.4 Removing
Duplex Driver PCB
1) Remove the 4 screws [1], and detach the duplex
driver PCB [2].
F-12-78

12.5.13 Relay PCB 1

12.5.13.1 Removing the Upper
Rear Cover
1) Remove the upper rear cover.
12.5.13.2 Removing the Lower
Rear Cover
1) Remove the lower rear cover.
12.5.13.3 Removing the Left
Upper Rear Cover
1) Removing the left rear upper cover.
12.5.13.4 Removing
Controller Box Cover
1) Disconnect the connector J1512 [1] from the power
distribution PCB, and free the harness from the
wire saddle [2]; then, remove the 6 screws [3], and
detach the main controller cover [4].
the
0000-5314
0000-5303
0000-5304
0000-5307
the
0000-5305
F-12-79
12.5.13.5 Removing the DC
Controller PCB Cover
1) Remove the 8 screws [1], and detach the DC
controller PCB cover [2].
F-12-80
When Attaching the DC Controller PCB Cover
When attaching the cover, take care so that the cut-off
will not come into contact with the latch of the flat
cable. Otherwise, the flat cable can come loose.
Chapter 12
0000-5306
12-33