Canon iR C3200 Series Service Manual page 1103

Y-PTN
Used to eliminate 100 mm horizontal lines.
0: Don't imprint Y dot patterns on intermediate transfer belt.
1: Imprint Y dot patterns on intermediate transfer belt (only when reading color documents; value at time of factory
shipment/value after RAM clear).
2: Imprint more Y dot patterns on intermediate transfer belt than when value of 1 is set.
K dot patterns are imprinted on intermediate transfer belt during monochrome document reading only when value of
2 is set.
SCR-SLCT
Used to select half-tone process for photographic printing paper/photo mode.
0: Use error diffusion method
1: Use low-line-count screen (value at time of factory shipment/value after RAM clear)
2: Use high-line-count screen
TMC-SLCT
Used to select coefficient used in error diffusion process.
0: Low granularity/low dot stability for Y/M/C/Bk
1: Y/M/C -> Low granularity, low dot stability, Bk -> high granularity, low dot stability (value at time of factory
shipment/value after RAM clear)
2: High granularity/low dot stability for Y/M/C/Bk
LOW-DZL
Used to change document illumination lamp lighting (document size detection operation) time.
0: Normal operation (value at time of factory shipment/value after RAM clear)
1: Dazzle reduction mode (Document illumination lamp is lit only once momentarily to detect document size.)
D-CLN-TM
Cleans light-sensitive drum surface.
Whenever possible, avoid using this setting during normal operation.
CAL-SW
Used to switch condition for executing calibration control.
Whenever possible, avoid using this setting during normal operation.
CLN-PTH
Sets threshold value (number of sheets) for starting drum cleaning sequence.
Whenever possible, avoid using this setting during normal operation.
CLN-VTH
Sets threshold value (image density) for starting drum cleaning sequence.
Whenever possible, avoid using this setting during normal operation.
DEVL-VTH
Sets threshold value (video count) for starting toner forcible consumption sequence.
Whenever possible, avoid using this setting during normal operation.
FTPTXPN
Used to specify port (FTP) number to send to.
0 to 65535 (16-bit value) (Value at time of factory shipment/value after RAM clear: 21)
Chapter 18
0006-1178
0006-1180
0006-1181
0006-1182
0006-1183
0006-1186
0006-1187
0006-1190
0006-1194
0006-1213
18-97