Chapter 16
16.3.10.62 E514 Error code detail There is a fault in stack processing (clockwise
direction)
Symptom
E514 There is a fault in stack processing (clockwise direction). (Error code detail)
Description
Detail
16.3.10.63 E530 Error code detail There is a fault in alignment.(Finisher-N1)
Symptom
E530 There is a fault in alignment.(Finisher-N1) (Error code detail)
Description
Detail
0001
0002
16-150
Description
The stack processing motor (M2) or
the stack delivery lever home position
sensor (S8) is faulty. The connector is
disconnected. The stack delivery belt
or the return roller is faulty.
Description
There is an excess load on the
alignment motor (M3), aligning
plate home position sensor (PI6),
or aligning plate.
There is an excess load on the rear
alignment motor (M3), rear
aligning plate home position sensor
(PI6), or rear aligning plate.
T-16-27
Timing of detection
The stack delivery lever fails to
reach its home position when the
stack processing motor has been
driven for a specific period of time
at start of operation.
T-16-28
Timing of detection
The aligning plate does not leave the
aligning plate home position sensor
when the alignment motor has been
driven for 2 sec.
The aligning plate does not return to its
home position when the aligning plate
motor has been driven for 2 sec.
0002-1692
0002-1695