Removing The Drive Roller - Canon iR C3200 Series Service Manual

Chapter 9
9.8.3.4 Removing the Drive
Roller
1)
1) The spring found at the front is under pressure;
thus, starting at the front can cause the spring to
snap out. Be sure to start at the rear.
2) When removing the gear, be sure to take care not to
lose the parallel pin.
At the rear, remove the following: E-ring [1], washer
[2], bearing [3], E-ring [4], gear [5], parallel pin [6],
gear butting spacer [7], bearing [8], and 2 E-rings [9].
F-9-104
2) At the front, remove the following: E-ring [1],
washer [2], bearing [3], E-ring [4], washer [5],
spring [6], washer [7], bearing [8], grounding plate
[9].
9-62
0000-4529
3) Remove the bearing [1] found at the rear, and free
the drive roller [2] from the cut-off [A] of the frame
found at the front.
Points to Note When Attaching
When attaching the washer, spring, and washer at the
front, be sure to fit the E-ring after forcing down the
spring together with the washer until the E-ring
groove [A] of the drive roller shaft is in view.
F-9-105
F-9-106