Canon iR C3200 Series Service Manual page 987

Code Detail Description
0001 The No. 1 mirror base moves
forward but does not move from
its home position.
E220 A fault has occurred in activating the scanning lamp.
0000 The intensity of the scanning
lamp has dropped.
E240 The communication between the main motor controller and the DC controller is faulty.
0000
0002
E243 The control panel is faulty.
0000
E248 The EEPROM on the reader controller PCB is faulty.
0000
E302 A fault has occurred in relation to shading correction.
0000 A time-out has occurred in
shading operation.
0001 A time-out has occurred in gain/
offset correction by the analog
processor.
E315 The image data is faulty.
0001
Timing of detection
The home position sensor does not
go OFF within a specific period of
time.
During shading adjustment at time
of power-on, the intensity detected
by the CCD is below a specific
level.
There is a fault in the serial
communication between the main
controller and the DC controller.
While print is under way, there is no
appropriate response from the DC
controller within a specific period
of time.
There is a fault in the
communication between the
controller and the control panel.
The ID stored in EEPROM (read
when the main power is turned on)
and the ID stored in the flash ROM
fail to match.
The shading processing does not
end 1 sec after it has started.
The gain/offset correction (setting
operator) by the analog processor
does not end 1 sec after it has
started.
A time-out condition has occurred
in encoding/decoding processing of
image data.
Chapter 17
17-7