Removing The Auto Registration Sensor Pcb - Canon iR C3200 Series Service Manual

F-9-275
Point to Note When Attaching the Pattern Reader
Unit
<Mounting to the Machine>
1) Match the boss [1] with the rail [2].
F-9-276
2) While pushing the cleaning member [1] to the right,
fit it in while taking care so that it will not hit the
slide rail [2] of the intermediate transfer unit on the
side of the machine's side plate.
F-9-277
3) Connect the connector [1]; then, while pulling the
escape lever [2] toward the front, hook the plate [3]
on the left/right claw [4], and secure it in place with
a screw [5] over the screw hole.
F-9-278
9.8.19.5 Removing the Auto
Registration Sensor PCB
1) Remove the 3 screws [1], and detach the plate
found to the rear of the pattern reader unit [2].
Chapter 9
0000-4553
9-99