F-12-228
12.5.29.12
Removing
Manual Feed Cooling Fan
Duct
1) Slide out the manual fee unit; then, disconnect the
connector [1] and remove the 2 screws [2] to detach
the manual feed cooling fan duct [3].
F-12-229
12.5.29.13
Removing
Drum ITB Motor Mounting
Points to Note When Removing the Drum ITB
Motor Mounting
To remove, put your hand into the inside where you
have slid out the manual feed unit; then, while holding
down the swing plate [1] found to the rear of the drum
drive unit, remove from the machine's rear side plate.
The drum drive unit is hooked on the protrusion from
the
0000-5337
the
0000-5338
the rear side plate; lift it slightly to detach.
F-12-230
1) Free the DC harness [1] found at the front of the
drum ITB motor base from the cable clamp [2].
F-12-231
2) Disconnect the 2 connectors [1], and remove the 3
screws [2]; then, detach the drum ITB motor base
[3].
Chapter 12
12-69