Canon iR C3200 Series Service Manual page 860

Chapter 16
16.3.4.7.9 Even after installing send kit, 'SEND' tab is not displayed on LCD
[ Case in the field ]
Description
Installation of the send kit has been successfully completed.
Cause
There is a case in the field that the symptom was corrected by reinstalling the Resolution Switching Board.
Field Remedy
It is possible that the Resolution Switching Board is not properly recognized. So, try reinstalling it. If the
symptom is not corrected, replace it with a new one.
16.3.4.7.10 Unable to format or install HDD
[ Manual-related ]
Description
SST Ver.1.41 is used.
Field Remedy
The version of the SST which is applicable to iRC3200 is Ver.1.63 and later. Upgrade the SST to Ver.1.63 and
later.
16.3.4.7.11 #705
[ Manual-related ]
Cause
The data size of image that is being sent is larger than that specified in 'Maximum Data Size for Sending'.
Field Remedy
Change the maximum data size for sending: in user mode [System Settings>Communications Settings>E-mail/
I-Fax Settings>Maximum Data Seize for Sending].
16.3.4.7.12 Air bubbles are generated on surface of glossy paper
[ Case in the field ]
Cause
There is a case in the field that this symptom was corrected by changing the fixing temperature control.
Field Remedy
1. Select 'Glossy Paper' that appears under 'Special Paper Types' for stack bypass paper selection.
2. If air bubbles are still generated, try changing the fixing temperature control in service mode
[COPIER>Option>BODY>TEMP-TBL].
0: 190 C (default)
1: 185 C
2: 180 C
16-86
0004-0681
0004-0719
0004-0733
0004-2974