E719 Error Code Detail The Coin Vendor Is Faulty; E719-0011 Error Code After The Cable Is Disconnected Because Of A; Scanning Fault In Card Reader D - Canon iR C3200 Series Service Manual

Detail
0000

16.3.10.108 E719 Error code detail The coin vendor is faulty.

Symptom
E719 The coin vendor is faulty. (Error code detail)
Description
Detail
0000
0011

16.3.10.109 E719-0011 Error code After the cable is disconnected because of a

scanning fault in card reader D1

Symptom
E719-0011 is displayed when the cable is disconnected because of a scanning fault in card reader D1.
Description
At the time of installation of the card reader, service mode COPIER > Function > INSTALL > CARD is
performed and then the main unit communicates with the card reader D1. At this time, if the cable is suddenly
disconnected, E000719-0011 will occur.
Cause
Communication error when the card reader D1 cable is disconnected.
Field Remedy
1) In service mode level 1 COPIER > Function > CLEAR > ERR, press OK and then turn OFF the main switch.
2) Turn ON the power.
3) When the main unit starts up, 'Department ID and Personal Identification Number entry window' will appear.
Press OK in service mode level 1 COPIER > Function > CLEAR > PWD-CLR and close service mode.
T-16-58
Description
The communication with the NE controller is disrupted and
is not resumed within 3 sec thereafter.
T-16-59
Description
The coin vendor cannot be detected at startup.
The card reader cannot be detected at startup.
Timing of detection
Timing of detection
Chapter 16
0002-1801
0002-1960
16-173