Chapter 6
F-6-55
6.4.6.4 Removing the CCD
Unit
4) Remove the 2 flat cables [1] of the reader controller
PCB, 2 screws [2], and leaf spring [3]; then, detach
the CCD unit [4].
F-6-56
6.4.6.5 After Replacing the
CCD Unit
When you have replaced the CCD unit, enter the
values (for color displacement correction in sub
scanning direction) indicated on the label attached to
the unit in service mode:
COPIER>ADJUST>CCD>CCDU-RG/GB
Use it to enter the image position correction value
(dependent on the CCD unit).
6-24
6.4.7 Fuse PCB (option)
6.4.7.1 Removing the Reader
Rear Cover
1) Remove the 2 cable clamps [1] to free the reader
power cable.
0000-4429
2) Disconnect the reader controller communications
cable.
3) Remove the 7 screws [1], and detach the reader rear
cover [2].
0000-4430
6.4.7.2
Copyboard
Closed Sensor Mounting
1) Remove the 2 screws [1], and detach the sensor
F-6-57
F-6-58
Removing
Cover
base [2].
0000-4411
[1]
the
Open/
0000-4412