Canon iR C3200 Series Service Manual page 1113

18.6.4.1.2 USER
SIZE-DET
Used to turn document size detection function ON/OFF.
0: OFF
1: ON (value at time of factory shipment/value after RAM clear) (When pressure plate opens/closes, optics don't
light, eliminating dazzle.)
DATE-DSP
Used to switch date display.
0: 'YYMM/DD
1: DD/MM'YY
2: MM/DD/YY
MB-CCV
Used to select whether to restrict mailbox control card users.
0: Don't restrict
1: Restrict
TRY-STP
Used to set mode in which output stops when tray is full.
0: Normal mode (Interrupted when finisher tray is full.)
1: Interrupted only by height detection
CNT-DISP
Used to select whether to display serial number when counter check key is pressed.
0: Display serial number.
1: Don't display serial number.
OP-SZ-DT
Used to turn document size detection when pressure plate is open ON/OFF.
0: Enter document size in control panel.
1: Detect document when start key is turned ON with pressure plate open.
NW-SCAN
Used to select whether to permit network scan function.
0: Don't permit
1: Permit (Invalid when UFR board or open interface board isn't connected.)
HDCR-DSP
Used to turn off display of user mode hard disk clear mode and switch clear operations.
0: Don't display and don't clear
1: Clear once with zeroes
2: Clear once with random data
3: Clear 3 times with random data (mode displayed for settings 1 to 3)
JOB-INVL
Used to set job interval during interrupt.
0: Standard setting (Output next job continuously during interrupt copy job.)
1: Start output of next job after last sheet of interrupt copy job has been delivered.
2: Start output of next job after last sheet of any job has been delivered.
Chapter 18
0001-2745
0006-1247
0006-1248
0006-1253
0006-1254
0006-1255
0006-1258
0006-1259
0006-1262
18-107