Canon iR C3200 Series Service Manual page 989

Code Detail Description
The feeder motor (M2) fails to
rotate. The feeder motor clock
sensor (SR1) is faulty.
E404 There is a fault in the delivery motor.
The face-down delivery motor
(M3) fails to rotate. The
facedown delivery motor clock
sensor (SR7) is faulty.
E500 There is a fault in finisher communication.
There is a fault in data
communication.
E503 There is a fault in saddle communication.
0002 There is a fault in data
communication.
E504 There is a fault in stack size detection.
0001 The height sensor (PS1) is faulty.
0002 The height sensor (PS1) is faulty.
0003 The connector of the height
sensor (PS1) is faulty.
0004 The DIP switch for the height
sensor (PS1) is not adjusted
correctly.
E505 There is a fault in the backup RAM.
0001 The checksum value of the
finisher controller PCB is faulty.
E512 There is a fault in delivery.
Timing of detection
The feeder motor encoder pulse is
not detected within 0.3 sec after the
DF feeder motor drive signal has
been turned ON.
The face-down delivery motor
encoder pulse is not detected within
0.3 sec after the face-down delivery
motor drive signal has been turned
ON.
The communication between the
machine and the finisher remains
disrupted for 5 sec or more.
The communication between the
saddle stitcher controller PCB and
the finisher controller PCB remains
disrupted for 5 sec or more.
The communication between the
height sensor and the finisher
controller PCB is prevented. Or,
there is a fault in the
communication data.
The communication between the
height sensor and the finisher
controller PCB is prevented for 0.1
sec or more.
This fault is detected at power-on.
There is a fault in the adjustment of
the sensor by the DIP switch.
This fault is detected at power-on.
Chapter 17
17-9