7) Remove the 4 screws at the rear [1], and pull out the
link plate (front) [2]; then, rotate it 180 deg.
F-9-99
When you have pulled out the belt, keep it upright or
place it on paper to avoid damage.
After bending the transfer frame, pull out the transfer
belt [1] upward.
F-9-100
Check to make sure that the secondary transfer
internal roller is free of soiling. If dirt is found, clean
it with alcohol.
Points to Note When Attaching the Intermediate
Transfer Belt
1) Attach the intermediate transfer belt so that the
marking on its surface is to the rear.
F-9-101
2) When fitting the belt, place the unit in a low
position so that the belt may be fitted from above
and straight down.
F-9-102
3) Check to make sure that the edge [A] of the belt
does not ride over the rib [B] of the tension roller.
[1]
F-9-103
Chapter 9
[1]
[2]
[2]
[A]
[2]
[A]
9-61