Smudged/Streaked - Canon iR C3200 Series Service Manual

Chapter 16
16.3.2.7.23 Color voids at image lead edge when outputting SRA3 or 12x18" paper
[ Verified by Canon Inc. ]
Field Remedy
When outputting SRA3 or 12x18" paper under the measure for color displacement on thick paper activated in
service mode, color voids may occur at the image lead edge.
This symptom has been corrected with the System Ver.10.01, so upgrade it to Ver.10.01 and later if this
happens.
If the following service mode is set at [1], the measure for color displacement is activated: Service mode (level
2) [COPIER> Option> BODY> CLR-SHIFT> 1].
16.3.2.7.24 PS-C1: When outputting data created with Illustrator on MacOS9.2.2, image is printed
partially
[ Verified by Canon Inc. ]
Field Remedy
When outputting the data created with Illustrator 8/9/10 on MacOS9.2.2, most of the image may lack.
This symptom has been corrected with the PS-C1 system Ver.1.1.1, so upgrade it to Ver1.1.1 and later if this
happens.

16.3.2.8 Smudged/Streaked

16.3.2.8.1 Soiled image due to waste toner
Symptom
Soiled image due to waste toner
Cause
The gear at the rear side in the waste toner feed unit is missing. As the waste toner screw is not activated, waste
toner overflows without being delivered.
Field Remedy
Install the gear (25T Gear: FS7-0579) driving the waste toner screw.
16.3.2.8.2 Black lines randomly appear on the printed image when the original is set on the ADF.
Symptom
Black lines randomly appear on the printed image when the original is set on the ADF.
Description
Black lines randomly appear on the printed image when the original is set on the ADF.
Field Remedy
By decreasing the value of the Parameter instructedbelow by 10 from factory setting, the reading possition will
16-54
0004-9762
0004-9763
0002-3602
0002-1581