E602-0X02 Error Code; E602-0001 Error Code; E602-0402 Error Code: At Power-On Upon Installation, Irc - Canon iR C3200 Series Service Manual

16.3.10.92 E602-0x02 Error Code

[ Verified by Canon Inc. ]
< Field Remedy >
When the power is turned ON, iRC3200 checks the control table for HDD stored in SRAM on the SRAM board.
E602-0x02 can possibly be displayed during checking unassigned field in SRAM.
This symptom has been corrected with the system Ver.11.03, so upgrade it to Ver.11.03 and later if this happens.

16.3.10.93 E602-0001 Error Code

[ Verified by Canon Inc. ]
Cause
Because of temperature rising around iRC3200, 5V input voltage into the HDD will become unsteady and
finally the HDD will detect low voltage input, leading to E602-0001 indication.
Field Remedy
When E602-0001 is displayed, check the 8-digit lot number on the DC Fuse PCB. If the last two digits show
[01] or [02], replace the PCB with [03] or bigger.
DC Fuse PCB: FG3-2337

16.3.10.94 E602-0402 Error Code: At power-on upon installation, iRC3220

[ Case in the field ]
Description
When E602-0402 was displayed at power-on upon installation, MN-CONT clear was executed and the symptom
was solved. When this symptom occurs, follow the steps in Field Remedy.
E602-0402 can be displayed when the partition FSTPDEV inside the HDD is faulty. The detail code indicates a
file system error.
Field Remedy
1. In service mode [COPIER> Function> CLEAR> MN-CONT], press OK. The host machine will restart
automatically.
2. Turn the control panel switch OFF and then turn the main power switch OFF/ON.
Note: MN-CONT clear will erase all the image data stored in the HDD.
16.3.10.95 E604 Error code detail
(SDRAM).
Symptom
E604 There is a shortage in image memory (SDRAM). (Error code detail)
Description
Detail
0000
There is a shortage in image memory
T-16-49
Description
The remaining space in image memory is inadequate for
the intended write/read operation.
Timing of detection
Chapter 16
0005-3232
0005-8612
0008-1586
0002-1778
16-167