Canon iR C3200 Series Service Manual page 859

16.3.4.7.5 Card Reader-D1: Cautions upon installation
Symptom
Card Reader-D1: Cautions upon installation
Field Remedy
The installation procedures for the Card Reader-D1 is that the lowest number of the cards that are to be used
should be entered in service mode [COPIER>Function>INSTALL>CARD], and then the power is turned OFF/
ON.
DO NOT turn the power OFF until the entered number is displayed on the LCD (it will take 5 to 10 seconds).
It is possible that a mismatch in the data of SDRAM will occur and the machine will not start up with a message
'Starting up. Please wait.'.
16.3.4.7.6 Paper stacking failure: when outputting media of low rigidity in a high humidity
environment
Symptom
The medium tends to wave or curl if stacking is poor, as when the medium is of high rigidity and used in a high
humidity environment.
Cause
The medium absorbs moisture, and tends to curl appreciably downward.
Field Remedy
Set'1'for the following in service mode: COPIER>OPTION>BODY>DEVL-FAN
16.3.4.7.7 Control key not working
[ Manual-related ]
Field Remedy
In service mode [COPIER>Function>INSTALL>KEY], set it at '1'.
16.3.4.7.8 PS-C1: Calibration cannot be performed
[Case in the field]
Cause
There is an actual case in the field that activating 'Accept Scan Job with Unknown IDs' solved the problem.
Field Remedy
If 'Dept. ID Management' is activated, calibration cannot be performed with 'Accept Scan Job with Unknown
IDs' is set at 'Off'. So, select 'ON' for 'Accept Scan Job with Unknown IDs' and then perform calibration.
Chapter 16
0002-2656
0002-3536
0003-2739
0003-3070
16-85