Canon iR C3200 Series Service Manual page 446

Chapter 10
F-10-44
When Attaching the DC Controller PCB Cover
When attaching the cover, take care so that the cut-off
will not come into contact with the latch of the flat
cable. Otherwise, the flat cable can come loose.
[1]
F-10-45
10.10.6.7 Removing the Fixing
Heat Discharge Fan
1) Remove the 2 screws [1], and disconnect the
connector [2]; then, detach the fixing heat discharge
fan [3].
10-40
10.10.6.8
Developing Drive Unit
1) Disconnect the connector [2] of the developing
motor [1], and free the harness [3] from the cable
clamp [4].
2) Remove the 2 screws [1], and detach the main
controller base [2].
0000-4763
F-10-46
Removing the
F-10-47
F-10-48
0000-4764