Removing The Scanning Lamp - Canon iR C3200 Series Service Manual

Chapter 6
F-6-25
6.4.2.4 Removing the Scanning
Lamp
1) Peel the sheet [1] (1 each at front and rear) of the
reader frame.
F-6-26
2) Disconnect the connector [1] from the inverter
PCB, and free the harness [3] from the edge saddle
[2] of the frame.
F-6-27
6-16
3) Slide the No. 1 mirror base [1] until it matches
against the cut-off in the frame; then, remove the 3
screws [2], and remove the scanning lamp [3].
0000-4426
Points to Note When Attaching the Scanning
Lamp
To mount the scanning lamp, route the harness [1] of
the lamp unit through the white guide [2] of the No. 2
mirror base and then the black harness guide [3];
thereafter, connect the connector [4] to the inverter
PCB.
F-6-28
F-6-29