Canon iR C3200 Series Service Manual page 483

10.10.25.5 Removing
Pickup Unit
1) Disconnect the connector [1], and remove the 4
screws [2]; then, detach the pickup unit [3].
F-10-205
10.10.25.6 Removing the Pick-
up System Sensor Mounting
Plate
1) Remove the 2 screws [1] at the rear, and remove the
bracket [2].
F-10-206
2) Disconnect the connector [1], and remove the screw
[1]; then, detach the cassette pickup solenoid [3].
Thereafter,remove the 5 screws [4], and detach the
sensor mounting plate [5].
the
0000-4722
0000-4723
F-10-207
10.10.25.7 Mounting the Pick-
up System Sensor Mounting
Plate
Points to Note When Mounting the Sensor
Mounting Plate
Any of the gears can drop off. When attaching the
sensor mounting plate, be sure that the pickup unit
will not face downward.
1) Attach the bushing [1] to the frame; then, attach the
gear shaft [2].
F-10-208
2) Fit the 6 locations [A] indicated in the figure firmly
into the holes of the mounting plate; then, secure
the sensor mounting plate [2] in place.
Chapter 10
0000-4725
10-77