Removing The Environment Sensor Pcb; Removing The Reader Controller - Canon 1000 Service Manual

4. MECHANICAL SYSTEM
3) Remove the rear cover 1/2/3.
4) Disconnect the two connectors, and remove
the four screws; then, remove the power
supply cooling fan unit.
5) Disconnect all connectors from the DC power
supply PCB, and remove the four screws [3];
then, slide out the DC power supply PCB [4].
[3]
[3]
Figure 4-1103-7
8. Removing the Environment
Sensor PCB
1) Remove the multifeeder assembly.
2) Disconnect the connector [1], and remove the
two PCB supports [2]; then, remove the
environment sensor PCB [3].
[3]
[2]
Figure 4-1101-8
4-110
COPYRIGHT © 2001 CANON INC.
[3]
[4]
[3]
[1]
CANON CLC1000/1000S/3100 REV.2 MAY 2001 PRINTED IN JAPAN (IMPRIME AU JAPON)

9. Removing the Reader Controller

1) Remove the digital cover [4].
2) Remove the four screws [1], and remove the
reader controller cover [2].
[1]
[2]
[1]
Figure 4-1101-9
3) Disconnect the eight connectors [3], and
remove the seven screws [4]; then, remove
the reader controller [5].
[3]
[5]
[4]
[4] [3]
Figure 4-1102-9
[1]
[4]
[3]
[3] [4]
[4]