1. Push it in the direction of the arrow [1] indicated on the top edge of the drum unit.
2. After setting the drum unit in place, be sure to store away the protective cover.
Holding the protective cover [2] level, push in the drum unit (Y) [3] to set; the units are Y, M, C, and Bk, starting
from the left.
5)
When pulling out the sealing tape, be sure to hold the drum unit in place so that the drum unit will not slide out.
Pull out the sealing tape [1].
6) Set the drum units for other colors (M, C, Bk) in the same way.
7) Close the drum unit cover, and shift the open/close lever back to its initial position.
8) Shift the intermediate transfer unit releasing lever back to its initial position.
9) Close the front cover.
F-2-167
F-2-168
Chapter 2
2-67