Cisco MDS 9124 - Fabric Switch Reference page 1548

zoneset (configuration mode)
S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m
The zoneset distribute full vsan command applies to existing VSANs; it has no effect on VSANs that
have not yet been created.
To replace the active IVR zone set with a new IVR zone set without disrupting traffic, activate the new
Note
IVR zone set without deactivating the current active IVR zone set.
Examples The following example activates a zone set named gottons in VSAN 333.
switch# config terminal
switch(config)# zoneset activate name gottons vsan 333
Zoneset Activation initiated. check zone status
The following example clones a zone set named zSet1 into a new zoneset named zSetClone in VSAN 45.
switch(config)# zoneset ?
activate
clone
distribute
name
rename
switch(config)# zoneset clone ?
<WORD>
switch(config)# zoneset clone existing ?
<WORD>
switch(config)# zoneset clone existing new ?
vsan
switch(config)# zoneset clone existing new vsan ?
<1-4093>
switch(config)# zoneset clone existing new vsan 1 ?
<cr>
switch(config)# zoneset clone existing zSet1 zSetClone vsan 45
The following example distributes the operational values for the default zone to all zone sets in VSAN
22.
switch(config)# zoneset distribute full vsan 22
Related Commands Command
system default zone
distribute full
show zoneset
Cisco MDS 9000 Family Command Reference
27-24
Activate a zoneset
Zoneset clone command
Enable zoneset propagation
Configure a zoneset
Zoneset rename command
Current zoneset name (Max Size - 64)
New zoneset name (Max Size - 64)
Clone zoneset name on a vsan
VSAN id
Carriage Return
Description
Configures default values for distribution to a zone set
Displays zone set information.
Chapter 27
OL-16217-01, Cisco MDS SAN-OS Release 3.x
Z Commands