Gvrp Configuration - 3Com 4200G 12-Port Configuration Manual

Protocol Specifications

GVRP Configuration

Configuration
Prerequisite
Configuration Procedure
Table 41describes the packet fields Figure 23.
Table 41 Description of the packet fields
Field Description
Protocol ID Protocol ID
Message Each message consists of two parts:
Attribute Type and Attribute List.
Attribute Type It is defined by specific GARP
application.
Attribute List It contains multiple attributes.
Attribute Each general attribute consists of three
parts: Attribute Length, Attribute
Event and Attribute Value.
Each LeaveAll attribute consists of two
parts: Attribute Length and LeaveAll
Event.
Attribute Length The length of the attribute
Attribute Event The event described by the attribute
Attribute Value The value of the attribute
End Mark End mark of the GVRP PDU.
GVRP is defined in IEEE 802.1Q standard.
The GVRP configuration tasks include configuring the timers, enabling GVRP, and
configuring the GVRP port registration mode.
The port on which GVRP will be enabled must be set to a trunk port.
Table 42 Configuration procedure
Operation Command
Enter system view system-view
Configure the garp timer leaveall timer-value
LeaveAll timer
Enter Ethernet port interface interface-type
view interface-number
Configure the Hold, garp timer { hold | join | leave }
Join, and Leave timer-value
timers
Exit and return to quit
system view
GVRP Configuration
Value
1
—
The attribute type of GVRP is 0x01.
—
—
2 to 255
0: LeaveAll Event
1: JoinEmpty
2: JoinIn
3: LeaveEmpty
4: LeaveIn
5: Empty
The attribute value of GVRP is the
VID.
—
Description
—
Optional
By default, the LeaveAll timer is set to
1,000 centiseconds.
—
Optional
By default, the Hold, Join, and Leave
timers are set to 10, 20, and 60
centiseconds respectively.
—
63