Cisco AJ732A - MDS 9134 Fabric Switch Command Reference Manual page 1594

vrrp
S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m
vrrp
To enable VRRP, use the vrrp command in configuration mode. Use the no form of the command to
revert to the factory defaults or to negate a command.
Syntax Description ipv4-vr-group-number
address ip-address
secondary
advertisement-interval
seconds
authentication
Cisco MDS 9000 Family Command Reference
25-4
vrrp ipv4-vr-group-number
{address ip-address [secondary] |
advertisement-interval seconds |
authentication {md5 keyname spi index | text password} |
preempt |
priority value |
shutdown |
track interface {mgmt 0 | vsan vsan-id}
ipv6 ipv6-vr-group-number
{address ipv6-address |
advertisement-interval centiseconds |
preempt |
priority value |
shutdown |
track interface {mgmt 0 | vsan vsan-id}}
}
vrrp ipv4-vr-group-number
no address ip-address [secondary] |
no advertisement-interval |
no authentication |
no preempt |
no priority |
no shutdown |
no track}
vrrp ipv6-vr-group-number
no address ipv6-address |
no advertisement-interval |
no preempt |
no priority |
no shutdown |
no track}
no vrrp ipv4-vr-group-number
no vrrp ipv6-vr-group-number
Specifies an IPv4 virtual router group number. The range is 1 to 255.
Adds or removes an IP address to the virtual router.
Configures a virtual IP address without an owner.
Sets the time interval between advertisements. For IPv4, the range is 1 to
255 seconds.
Configures the authentication method.
Chapter 25 V Commands
OL-18089-01, Cisco MDS NX-OS Release 4.x