Tlport Alpa-Cache - Cisco AJ732A - MDS 9134 Fabric Switch Command Reference Manual

tlport alpa-cache

S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m
tlport alpa-cache
To manually configure entries in an ALPA cache, use the tlport alpa-cache command
Syntax Description interface interface
pwwn pwwn
alpa alpa
Defaults Disabled.
Command Modes Configuration mode.
Command History Release
1.3(5)
Usage Guidelines Generally, ALPA cache entries are automatically populated when an ALPA is assigned to a device. Use
this command only if you wish to manually add further entries.
Examples
The following example configures the specified pWWN as a new entry in this cache
switch# config terminal
switch(config)# tlport alpa-cache interface fc1/2 pwwn 22:00:00:20:37:46:09:bd alpa 0x02
Related Commands Command
show tlport
Cisco MDS 9000 Family Command Reference
23-50
tlport alpa-cache interface interface pwwn pwwn alpa alpa
no tlport alpa-cache interface interface pwwn pwwn
Specifies a Fibre Channel interface.
Specifies the peer WWN ID for the ALPA cache entry.
Specifies the ALPA cache to which this entry is to be added.
Modification
This command was introduced.
Description
Displays TL port information.
Chapter 23 T Commands
OL-18089-01, Cisco MDS NX-OS Release 4.x