Zone-Attribute-Group Clone - Cisco AJ732A - MDS 9134 Fabric Switch Command Reference Manual

zone-attribute-group clone

S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m
zone-attribute-group clone
To clone a zone attribute group, use the zone-attribute-group clone command in configuration mode.
Syntax Description
origAttGrp-Name
cloneAttGrp-Name
vsan vsan-id
Defaults None.
Command Modes
Configuration mode.
Command History Release
2.1(1a)
Usage Guidelines To remove the zone attribute group, use the no form of the zone-attribute-group name command.
Examples The following example shows how to clone a zone attribute group with the original name
origZoneAttGrp to a copy named cloneZoneAttGrp on VSAN 45.
switch# config terminal
Enter configuration commands, one per line.
switch(config)# zone-attribute-group clone origZoneAttGrp cloneZoneAttGrp vsan 45
Related Commands Command
show zone-attribute-group
Cisco MDS 9000 Family Command Reference
27-18
zone attribute clone origAttGrp-Name cloneAttGrp-Name vsan vsan-id
Modification
This command was introduced.
Clones a zone attribute group from the current name to a new name.
Maximum length of names is 64 characters.
Specifies the VSAN ID. The range is 1 to 4093.
End with CNTL/Z.
Description
Displays zone attribute group information.
Chapter 27 Z Commands
OL-18089-01, Cisco MDS NX-OS Release 4.x