Table of Contents
Advertisement
Related
Documentation
Managing SRP Module Redundancy
Related
Documentation
Copyright © 2010, Juniper Networks, Inc.
Synchronize the NVS file system of the redundant SRP module to that of the primary
3.
SRP module.
host1#synchronize low-level-check all
NOTE: The SRP module reboots after synchronization is complete.
Understanding SRP Module Redundancy on page 16
Managing SRP Module Redundancy on page 21
Switching to the Redundant SRP Module on page 22
reload slot
synchronize
You can prevent the redundant SRP module from taking over when:
The primary SRP module experiences a software failure.
You push the reset button on the primary SRP module.
NOTE: If you do not configure this option, when troubleshooting an SRP
module, disconnect the other SRP module from the router. This action
prevents the redundant SRP module from taking over if you push the reset
button on the primary SRP module.
To configure this option:
Issue the disable-switch-on-error command.
1.
host1(config)#disable-switch-on-error
Synchronize the NVS file system of the redundant SRP module to that of the primary
2.
SRP module.
host1#synchronize low-level-check all
Understanding SRP Module Redundancy on page 16
Installing a Redundant SRP Module on page 20
disable-switch-on-error
synchronize
Chapter 2: Managing Module Redundancy
21
Advertisement
Table of Contents
Need help?
Do you have a question about the JUNOSE SOFTWARE FOR E SERIES 11.3.X - SERVICE AVAILABILITY CONFIGURATION GUIDE 2010-10-08 and is the answer not in the manual?