Table of Contents
Advertisement
radius include ascend-num-in-multilink
radius include tunnel-server-attributes
Copyright © 2010, Juniper Networks, Inc.
configured, the delegated prefix is sent to the RADIUS server in the Framed-Ipv6-Prefix
attribute in the immediate accounting, Acct-Stop, or Interim-Acct messages.
For static interfaces, although the prefix configured using the CLI command is used for
DHCPv6 Prefix Delegation instead of the value returned by the RADIUS server, the
immediate accounting, Acct-Stop, or Interim-Acct messages contain the prefix returned
from the RADIUS server. If this attribute is not returned from the RADIUS server, the
immediate accounting, Acct-Stop, or Interim-Acct messages do not report this attribute.
See radius include
Example
host1(config)#radius include delegated-ipv6-prefix acct-start enable
Use the no version to restore the default, disable.
[188] Ascend-Num-In-Multilink
Use the following command to manage the Ascend-Num-In-Multilink attribute.
radius include ascend-num-in-multilink
Use to include the Ascend-Num-In-Multilink attribute in Access-Request, Acct-Start,
or Acct-Stop messages.
You can control inclusion of the Ascend-Num-In-Multilink attribute by enabling or
disabling this command.
See radius include
Example
host1(config)#radius include ascend-num-in-multilink acct-start enable
Use the no version to restore the default, disable.
All Tunnel Server Attributes
Use the following command to manage all tunnel server RADIUS attributes.
radius include tunnel-server-attributes
Use to include all supported tunnel server attributes in Access-Request, Acct-Start,
or Acct-Stop messages.
When the router functions as an LNS with a terminating PPP, then the LAC tunnel
attributes are included.
You can control inclusion of all tunnel server attributes by enabling or disabling this
command.
See radius include
Chapter 3: Configuring RADIUS Attributes
211
Advertisement
Table of Contents
Troubleshooting
