Juniper JUNOSE SOFTWARE 11.2.X - BROADBAND ACCESS CONFIGURATION GUIDE 7-20-2010 Configuration Manual page 611

include ip-address
include mac-address
include virtual-router-name
ip auto-configure ip-subscriber
Copyright © 2010, Juniper Networks, Inc.
Use the no version to disable inclusion of the router hostname in the username.
See include hostname
Use to include the IP address in the username that is dynamically created by JunosE
subscriber management.
Example
host1(config-service-profile)#include ip-address
Use the no version to disable inclusion of the IP address in the username.
See include ip-address
Use to include the MAC address identifier in the username that is dynamically created
by JunosE subscriber management.
Example
host1(config-service-profile)#include mac-address
Use the no version to disable inclusion of the MAC address in the username.
See include mac-address
Use to include the virtual router name in the username that is dynamically created by
JunosE subscriber management.
Example
host1(config-service-profile)#include virtual-router-name
Use the no version to disable inclusion of the virtual router name in the username.
See include virtual-router-name
Use to configure an IP interface to support creation of dynamic subscriber interfaces.
The specified IP interface is considered the primary interface.
The router creates the required dynamic subscriber interfaces when the IP address is
assigned to the associated subscriber. The address might be assigned by an external
DHCP server, the DHCP local server, or the packet detect feature.
Use the include-primary keyword to specify that the primary interface can be assigned
to a subscriber. Use the exclude-primary keyword to specify that the primary interface
cannot be used for subscribers. The primary interface is not assigned to a subscriber
by default.
You can issue this command from Interface Configuration mode, Subinterface
Configuration mode, or Profile Configuration mode.
Example
Chapter 23: Configuring Subscriber Management
573