Juniper JUNOSE SOFTWARE 11.2.X - BROADBAND ACCESS CONFIGURATION GUIDE 7-20-2010 Configuration Manual page 358

Software for e series broadband services routers broadband access configuration guide
Table of Contents

Advertisement

JunosE 11.2.x Broadband Access Configuration Guide
line
login authentication
tacacs-server host
320
Use to specify accounting method lists used on a console or vty line. Consoles and
lines are initially configured with the default method list for all accounting service types
(for example, Exec, Commands).
Specify exec to capture accounting information for User Exec terminal sessions or
commands to capture accounting information for User Exec mode commands at the
indicated JunosE privilege level (0 through 15).
Specify the name of the method list to be applied to the line or console.
To disable accounting for a line or console, specify a nonexisting accounting method
list name (for example, noAccounting).
Example
host1(config)#accounting commands 12 listY
Use the no version to restore the default method list.
See accounting
Use to open or configure console or vty lines.
You can specify a single line or a range of lines. The range is 0 though 29 for vty lines,
0 for the console line.
Example
host1(config)#line vty 6 10
host1(config-line)#
Use the no version to remove a line or a range of lines from the configuration. Lines
that you remove will no longer be available for use by telnet, FTP, or SSH. When you
remove a vty line, the router removes all lines above that line. For example, no line vty 6
causes the router to remove lines 6 through 19. You cannot remove lines 0 through 4.
See line
Use to apply an authentication list to the vty lines you specified on your router.
Example
host1(config-line)#login authentication my_auth_list
Use the no version to specify that the router should use the default authentication list.
See login authentication
Use to add or delete a host to or from the list of TACACS+ servers.
You can optionally specify a nondefault port number, a host-specific key, a single
connection and a timeout interval.
Use the primary keyword to assign the host as the primary host.
Copyright © 2010, Juniper Networks, Inc.

Advertisement

Table of Contents
loading

This manual is also suitable for:

Junose 11.2

Table of Contents