Table of Contents
Advertisement
JunosE 11.2.x Broadband Access Configuration Guide
Related Topics
Monitoring Detailed Configuration Information about Specified Tunnels
Purpose
Action
Meaning
434
show l2tp switch-profile
Display detailed configuration information about specified tunnels.
To display detailed configuration information about specified tunnel by ip address:
host1#show l2tp tunnel virtual router default ip 172.31.1.98
L2TP tunnel 1/xyz is Up with 13 active sessions
L2TP tunnel 1/aol.com is Up with 13 active sessions
L2TP tunnel 1/isp.com is Up with 13 active sessions
L2TP tunnel 1/msn.com is Up with 13 active sessions
L2TP tunnel 1/mv.com is Up with 12 active sessions
5 L2TP tunnels found
To display detailed configuration information about specified tunnel:
host1#show l2tp tunnel detail 1/xyz
L2TP tunnel 1/xyz is Up with 13 active sessions
Configuration
Administrative state is enabled
SNMP traps are enabled
Tunnel address
Transport ipUdp
Virtual router default
Local address 192.168.1.230, peer address 172.31.1.98
Local UDP port 1701, peer UDP port: 1701
Tunnel status
Effective administrative state is enabled
State is established
Local tunnel id is 14529, peer tunnel id is 34
Sub-interfaces
total
Sessions
13
Statistics
packets
Control rx
14
Control tx
41
Data rx
67900944
Data tx
67900944
Control channel statistics
Receive window size = 4
Receive ZLB = 17
Receive out-of-sequence = 0
Receive out-of-window = 0
Transmit window size = 4
Transmit ZLB = 12
Transmit queue depth = 0
Retransmissions = 8
Tunnel operational configuration
Peer host name is 'Juniper-POS'
Peer vendor name is 'XYZ, Inc.'
Peer protocol version is 1.1
Peer firmware revision is 0x1120
Peer bearer capabilities are digital and analog
Peer framing capabilities are sync and async
Table 92 on page 435 lists the show l2tp tunnel command output fields.
active
failed
13
0
octets
discards
683
0
4666
0
67900944
0
67900944
0
errors
0
0
0
0
Copyright © 2010, Juniper Networks, Inc.
Advertisement
Table of Contents
Troubleshooting
