Using Tags With Radius Attributes; Table 146: Using Tags - Juniper JUNOSE SOFTWARE 11.2.X - BROADBAND ACCESS CONFIGURATION GUIDE 7-20-2010 Configuration Manual

JunosE 11.2.x Broadband Access Configuration Guide
646

Using Tags with RADIUS Attributes

Service Manager uses tagged RADIUS VSAs to enable a single RADIUS record to activate
multiple service sessions for a subscriber, with each session having unique attributes. A
particular tag identifies a specific Activate-Service attribute and all other RADIUS
attributes that are associated with that Activate-Service attribute.
You can specify a maximum of 8 tags (1–8), which enables you to activate up to eight
unique service sessions for a subscriber in a single RADIUS record. The following are
tagged VSAs—they must always have a tag in their RADIUS entry:
Activate-Service
Service-Statistics
Service-Timeout
Service-Volume
Service-Interim-Acct-Interval
Table 146 on page 646 describes an Access-Accept packet that activates the two services,
tiered and voice, for subscriber client1@isp1.com. Each service has its own unique tag,
enabling you to assign attributes for one service, but not the other. For example, the two
services have different timeout settings and different interim accounting intervals, and
statistics are enabled only for the tiered service.

Table 146: Using Tags

RADIUS Attribute
username
class
service-activation
service-timeout
service-statistics
service-interim-acct-interval
service-activation
service-timeout
service-interim-acct-interval
Tag Value
none client1@isp1.com
none (binary data)
2 tiered(1280000, 5120000)
2 18000
2 1
2 600
6 voice(100000)
6 1440
6 1200
Copyright © 2010, Juniper Networks, Inc.