Juniper JUNOSE SOFTWARE 11.2.X - BROADBAND ACCESS CONFIGURATION GUIDE 7-20-2010 Configuration Manual page 95

ip local pool warning
ip local shared-pool
ipv6-prefix-pool-name
Copyright © 2010, Juniper Networks, Inc.
host 1(config)#ip local pool addr_test snmpTrap
Use the no version to disable SNMP pool utilization traps.
See ip local pool snmpTrap
Use to set SNMP utilization warning threshold values.
Example
host1(config)#ip local pool addr_test warning 90 80
Use the no version to reset the attributes to their default values; high threshold 85,
abated threshold 75.
See ip local pool warning
Use to create a local shared address pool and to specify the DHCP address pool that
provides the addresses.
You can reference a DHCP address pool that has not yet been configured.
Example
host1(config)#ip local shared-pool sharedPool11 dhcpPool6
Use the no version to delete a specific local shared address pool.
See ip local shared-pool
Use to specify the name of the IPv6 local address pool from which the delegating
router allocates prefixes to the requesting routers for the domain that you are
configuring.
When a user is authenticated using a RADIUS server, the RADIUS server might return
one or more of the following attributes in the Access-Accept message in response to
the client authentication request:
Ipv6-NdRa-Prefix (VSA 26-129)
Framed-IPv6-Prefix (RADIUS IETF attribute 97)
Delegated-IPv6-Prefix (RADIUS IETF attribute 123)
Framed-IPv6-Pool (RADIUS IETF attribute 100)
The prefix or pool name that the authentication server returns in any of these attributes
of the RADIUS-Access-Accept message takes priority over the local prefix pool name
configured for the domain map.
If the pool name or prefix is not present in the RADIUS-Access-Accept message, the
IPv6 local address pool name configured using the ipv6-prefix-pool-name command
is used to delegate prefixes to requesting DHCPv6 clients.
The IPv6 local pool name is a character string up to 16 characters long.
Chapter 1: Configuring Remote Access
57