Cli Commands Used To Modify Radius Attributes; Radius Ietf Attributes - Juniper JUNOSE SOFTWARE 11.2.X - BROADBAND ACCESS CONFIGURATION GUIDE 7-20-2010 Configuration Manual

JunosE 11.2.x Broadband Access Configuration Guide
Table 43: CLI AAA Access Message RADIUS Attributes Supported
(continued)
Attribute
Number Attribute Name
[4] NAS-IP-Address
[6] Service-Type
[18] Reply-Message
[24] State
(Access-Request is only in
response to an
Access-Challenge)
[25] Class
[26-1] Virtual-Router
[26-18] Init-CLI-Access-Level
[26-19] Allow-All-VR-Access
[26-20] Alt-CLI-Access-Level
[26-21] Alt-CLI-Virtual-Router-Name
[26-25] Redirect-Vrouter-Name

CLI Commands Used to Modify RADIUS Attributes

RADIUS IETF Attributes

184
Access-Request
–
–
–
–
–
–
–
–
This section discusses the RADIUS Internet Engineering Task Force (IETF) attributes and
the Juniper Networks vendor-specific attributes that you can configure using CLI
commands.
For many attributes, you can configure the router to include the attribute in RADIUS
messages. For more information, see "Including or Excluding Attributes in RADIUS
Messages" on page 229.
You can also configure the router to ignore many attributes that it receives in
Access-Accept messages. For more information, see "Ignoring Attributes When Receiving
Access-Accept Messages" on page 229.
For a complete list of RADIUS attributes supported by JunosE Software, see "RADIUS
IETF Attributes" on page 249.
This section describes the RADIUS IETF attributes that you can configure using CLI
commands. The attributes are listed numerically—each attribute is followed by a list of
Access-Accept Access-Challenge
– –
–
–
–
–
–
–
–
–
–
–
Copyright © 2010, Juniper Networks, Inc.
Access-Reject
–
–
–
–
–
–
–
–
–
–