Table 144: Service Manager Radius Attributes - Juniper JUNOSE SOFTWARE 11.2.X - BROADBAND ACCESS CONFIGURATION GUIDE 7-20-2010 Configuration Manual

JunosE 11.2.x Broadband Access Configuration Guide
644

Table 144: Service Manager RADIUS Attributes

Attribute
Number Attribute Name
[1] User-Name (used with
Virtual-Router, Juniper
Networks VSA 26-1)
[8] Framed-IP-Address
(used with
Virtual-Router, Juniper
Networks VSA 26-1)
[26-65] Activate-Service
[26-66] Deactivate-Service
[26-67] Service-Volume
[26-68] Service-Timeout
[26-69] Service-Statistics
[26-83] Service-Session
[26-140] Service-Interim-Acct-
Interval
[31] Calling-Station-ID
RADIUS
Message Type VSA Description
Access-Accept Uniquely identifies the subscriber
session
Access-Accept Uniquely identifies the subscriber
session
Access-Accept Name of the service to be activated;
and CoA-Request includes parameter values; a tagged
VSA
Access-Accept Name of the service to be
and CoA-Request deactivated
Note: This VSA is only used by CoA.
Access-Accept Number of MB of traffic that the
and CoA-Request service can consume; the service is
terminated when output byte count
exceeds this value; a tagged VSA
Access-Accept Number of seconds that the service
and CoA-Request is to remain active; the service is
terminated when the time expires; a
tagged VSA
Access-Accept Statistics configuration; a tagged
and CoA-Request VSA:
0 = disable
1 = timestamp only
2 = timestamp and volume
For service Name of the service (including
sessions only: parameter values) with which the
Acct-Start statistics are associated
Acct-Stop
Interim-Acct
Access-Accept Number of seconds between
and accounting updates for a service; a
CoA-Request tagged VSA
Access-Accept Uniquely identifies the subscriber
session
Copyright © 2010, Juniper Networks, Inc.