Juniper Networks Vendor-Specific Attributes; [26-1] Virtual-Router; [26-10] Ingress-Policy-Name - Juniper JUNOSE SOFTWARE 11.2.X - BROADBAND ACCESS CONFIGURATION GUIDE 7-20-2010 Configuration Manual

JunosE 11.2.x Broadband Access Configuration Guide

Juniper Networks Vendor-Specific Attributes

radius ignore virtual-router
radius include ingress-policy-name
radius ignore ingress-policy-name
212
Example
host1(config)#radius include tunnel-server-attributes access-request enable
Use the no version to restore the default, disable.
This section describes the Juniper Networks vendor-specific attributes (VSAs) that you
can configure using CLI commands. The attributes are listed numerically and are followed
by descriptions about the commands that you can use to manage the attribute.

[26-1] Virtual-Router

Use the following command to manage the Virtual-Router RADIUS attribute.
radius ignore virtual-router
Use to cause the Virtual-Router attribute to be ignored in Access-Accept messages.
You can control this behavior by enabling or disabling this command.
See radius ignore
Example
host1(config)#radius ignore virtual-router enable
Use the no version to restore the default, disable.

[26-10] Ingress-Policy-Name

Use the following commands to manage the Ingress-Policy-Name RADIUS attribute.
radius include ingress-policy-name
radius ignore ingress-policy-name
Use to include the Ingress-Policy-Name attribute in Acct-Start or Acct-Stop messages.
You can control inclusion of the attribute by enabling or disabling this command.
See radius include
Example
host1(config)#radius include ingress-policy-name acct-start enable
Use the no version to restore the default.
Use to cause the Ingress-Policy-Name attribute to be ignored in Access-Accept
messages.
Copyright © 2010, Juniper Networks, Inc.