Monitoring L2Tp Dial-Out - Juniper JUNOSE SOFTWARE 11.2.X - BROADBAND ACCESS CONFIGURATION GUIDE 7-20-2010 Configuration Manual

l2tp dial-out target

Monitoring L2TP Dial-Out

Copyright © 2010, Juniper Networks, Inc.
host1#l2tp dial-out session reset 10.10.0.0
There is no no version.
See l2tp dial-out session reset
Use to define an L2TP dial-out target. When the router receives packets destined for
the target, it creates a dial-out session.
When you create a target, you must specify the following:
ipAddress—IP address of the target
ipAddressMask—IP address mask of the target
domainName—Domain name used in the outgoing call Access-Request message
profileName—Name of profile used to create the interface stack
Example
host1(config)#l2tp dial-out target 10.10.0.0 255.255.0.0 L2TP-dial-out.de.dt profile
dialOut
Use the default version to remove the L2TP dial-out route.
Use the no version to remove the L2TP dial-out route or target.
See l2tp dial-out target
To monitor L2TP dial-out, see:
"Monitoring Chassis-wide Configuration for L2TP Dial-out" on page 437
"Monitoring Status of Dial-out Sessions" on page 442
"Monitoring Dial-out Targets within the Current VR Context" on page 443
"Monitoring Operational Status within the Current VR Context" on page 444
Chapter 14: Configuring L2TP Dial-Out
411