[26-81] L2C-Information; [26-92] L2C-Up-Stream-Data; [26-93] L2C-Down-Stream-Data - Juniper JUNOSE SOFTWARE 11.2.X - BROADBAND ACCESS CONFIGURATION GUIDE 7-20-2010 Configuration Manual

radius include access-loop-parameters
radius include l2c-upstream-data
radius include l2c-downstream-data
Copyright © 2010, Juniper Networks, Inc.

[26-81] L2C-Information

Use the following command to manage the L2C-Information RADIUS attribute.
radius include access-loop-parameters
Use to include the L2C-Information attribute in Access-Request messages.
You can control inclusion of the L2C-Information attribute by enabling or disabling this
command. Inclusion is disabled by default.
See radius include
Example
host1(config)#radius include access-loop-parameters access-request enable
Use the no version to restore the default, disable.

[26-92] L2C-Up-Stream-Data

Use the following command to manage the L2C-Up-Stream-Data RADIUS attribute.
radius include l2c-upstream-data
Use to include the L2C-Up-Stream-Data attribute in Access-Request, Acct-Start, and
Acct-Stop messages.
You can control inclusion of the L2C-Up-Stream-Data attribute by enabling or disabling
this command. Inclusion is disabled by default.
See radius include
Example
host1(config)#radius include l2c-upstream-data access-request enable
Use the no version to restore the default, disable.

[26-93] L2C-Down-Stream-Data

Use the following command to manage the L2C-Down-Stream-Data RADIUS attribute.
radius include l2c-downstream-data
Use to include the L2C-Down-Stream-Data attribute in Access-Request, Acct-Start,
and Acct-Stop messages.
You can control inclusion of the L2C-Down-Stream-Data attribute by enabling or
disabling this command. Inclusion is disabled by default.
Example
host1(config)#radius include l2c-downstream-data access-request enable
Chapter 3: Configuring RADIUS Attributes
221